Control Box Replacement
Contact HandyTrac Technical Support with any questions.
service@handytrac.com or call 1-888-458-9994.
Monday - Friday, 8AM - 6PM EST
Read over these instructions before beginning. Do not throw away any equipment or boxes. Your control box styling may differ slightly from what is depicted.
Removing Keypad
Power off the system using the power switch at the bottom-right. If your system does not have a power switch, unplug the power from the wall.
Remove the hex-head screw from the bottom edge of the keypad.
This is the only screw that needs to be removed. Do not remove any screws from the control box (the black metal box the keypad is mounted on).
Remove the “L” shaped bracket by pulling it down off the keypad.
Disconnect the three cables:
DIN Cable - Pull down to remove the cable.
Ethernet Cable - Depress the locking tab and pull out.
Power Cable - Pull out.
Pull cables out through control box hole to access the lock, light, and switch connectors.
Disconnect lock, light, and switch cables in cabinet.
Push up on the keypad to remove it from the mount
Unscrew the control box from the wall. Carefully remove the control box, making sure no cables are still connected or snagged.
Mount the new control box to the wall and screw in to place. Use anchors where appropriate.
This sketch cannot currently be displayed in exports
Mount keypad on the mount
Reconnect the 3 cables to the datalog (DIN, Power, Ethernet).
Reconnect the cables inside cabinet and reattached to clips.
Test full functionality of the system by powering it on and requesting a key.
- Cabinet door(s) should open automatically when a key is requested.
- The keypad display should be bright and not flicker.
- Badges and keytags should be quickly recognized when scanned.
If you received a UPS Return label, located inside the shipping box, the old control box MUST BE RETURNED.
Call HandyTrac Technical Support at 1-800-665-9994 if you notice any issues or have any questions.